High speed Laser marking
and cutting system for knitted components
                             --ZS-CO₂10-19

    This system is specially designed for marking or cutting on various Knitted-capacitor components in the electronics industry. It is composed by ZS-CO₂10 High-Speed Laser Marking System and semi-automatic feeding system, electric ESP, and PRE Cut Machine. which can mark in either static state or dynamic state. Besides integrated design, high

(Click to see big pictrue)

speed(8,0000-20,0000pieces/day) convenience (changing characters only computer input), stability, low power consumption and small size, low cost are all its features. Fairly unique structure design and broad-banded black marble table, the system is connected with feeder so that it is particularly convenient for operators to do.

　

Main Technical Specifications：
1、Laser power：10 W；Laser wavelength：10.6μm； Laser life：≥45000hours(aeration after 10000)
2、Scanning speed：7000mm/sec.Working speed：3—8pcs/s
3、Cutting speed：＞Marking speed
4、Cutting diameter：φ0.45—φ1mm。
5、Marking scope：50mm×50mm。
6、Min. character：0.4mmhigh；Min. line width：0.08mm；
7、Marking position accuracy：±0.1mm.
8、Power input：220V/0.74kw。
9、Continuous operation for 24 hours without stop
10、Volume：800mm×950mm×1380mm

Main Configurations：
1、Host：CO₂High-Speed Vibrating Mirror Laser Marking System（ZS-CO₂10）
2、Semi-auto feeding system：Guide of feeding system、Feeding synchronous rotation  Group
3、Drive system：Motor and Driver Board
4、Cutting system：special cutting knife, cutting drive
5、Purification System ：electric  brushing and cleaning devices. (Suction mouth is reserved)
6、Control; system：Photoelectric sensors, micro-control system.
7、Other：tray

The Installing Environment for CO₂ series of Laser Marking Systems:
一. Power supply requests:
Power source: 220V±10% (single-phase), has independent electric wire
to meet the ground
Frequency: 50Hz
Electric current: 10A  

二. Working conditions:
Ambient temperature: 5 ~ 30℃
Relative humidity: <= 75% (no congeal)
The system should be placed on the space environment : clean, relatively no dust, no strong vibration body around ,without heat, ventilation, clean and bright, to ensure good ventilation, the system and the distance between the walls and other obstructions to maintain at least 0.6m
　

Electromagnetic environment: without strong electronmagetic interference, and the computer can work normally.

☆Watch out: Protect your body (especially your eyes) to avoid damage from the direct     Illumination of laser .

☆Read the product instructions first and carry on the operation according to the request strictly!

☆If the abnormal phenomenon appears, close the master switch first and then inspect.

☆Attention to the process of using the equipment such as a sudden power outages, we should close down all the switches. After that we should use it according to the normal sequence, otherwise this will cause great damage to equipment.

☆Keep the room and the surface of machine neat.

☆The working place should be equipped with cleaning and ventilation pipes to remove the dust and exhaust produced in the process.

☆After localization, we should adjust the earthquake-prevented foot pads according to the state of ground to make the floor of the equipment and the ground contact steadily and assume the horizontal shape. 

☆The laymen are not allowed to overhaul when the machine is opened in order to avoid electric shock accident because the electric circuit presents high-pressured condition when the system works.

[Return]